does the latest splitcam version (10.5.12) use gpu ressources at all, to traffic video data (as output source for input into skype)? Does it support nvenc or other gpu-based code, to decrease the load on the cpu?
Thanks for your reply. I by now updated my Windows 10 32-bit to the 64 bit-version and it works a lot better. Also I changed the power options and it does work fluently now, despite the old pc. Recordings are now possible up to 40 seconds, which is enough for my tasks.
But: is it possible to change the settings for recording via the stream options? Are ther more options for recordings than in the "settings" menu?
Hi, could someone look over the following recording-problem and try to help me solve it, please? Especially: Which better settings for my system do you suggest?
The Problem is: When I try to record video and audio to my hard disc (HDD, 650 GBs free), I get an error message ( see below) and cannot record more than 6 seconds. Also, sound is missing.
My System is: Windows 10 Pro (20H2), 32-bit, CPU: Intel Core 2 Duo 7400 (2x 2,8 GHz), RAM: 8 GB DDR2 Ram (800 Mhz), GPU: Nvidia Geforce GT 730 (2 GB RAM), driver: 23.21.13.9135 2 Webcams of different noname brands, both running with Windows-driver: 10.0.19041.964 Motherboard: Gigabyte GA EP 43-DS3
I use SplitCam Version 10.5.12 and these are my settings: General: Canvas: 1280x720, fps: 30, Second Layer /PiP: 640x480 @30 fps, Microphone: iRig MicCast HD Recording: same 1280x720, fps: 30
Restreaming parameters: Audio Encoder: AAC at 128 bits Video Encoder: Software H.264, Rate Control: CBR Video resolution: 1280x720 @ 30 fps Preset: "very fast", with keyframe at 2 secs, Profile: "high", 2500 kbits/sec Tune: "zerolatency", Buffer size: 2500 Kb
Error Message: "An error ocurred during streaming: Queue packets exceeded limit video encoder = 363. Average packet processing time = 51 (msec). Please check your streaming parameters. The most probable reason of this type of error is extremely high processor and meomry load." (Suggestions to change the recording and streaming parameters follow.)
I already unsuccessfully tried changing (inclusive saving, closing and restarting Splitcam in between): - fast encoder preset first to "superfast", then to "ultrafast", both times with keyframe at 2 secs, - chose the "baseline" profile and lowered its bitrate to 250 (!) Kb/sec, - tried different "Tune" presets, with its buffer size once at 2500 and then at 5000 Kb
Can anyone suggest adequate settings, or tell me, what the problem is, please?
